Witch Hat Cranky Face Emboss 3D Printed Cookie Stamp

Witch Hat Cranky Face Emboss 3D Printed Cookie Stamp

This embosser stamp from Sweet Themes features a Witch Hat with a Cranky Face design and comes with care and usage instructions. The 3D printed stamp shaped like a Witch Hat and is perfect for Halloween or Witch & Wizard themed parties or gifts!

- 12.5 x 12cm
- detailed imprint depth of 0.4cm.

Designed to work well with the Witch Hat Cookie Cutter.

Material
Printed with 100% food-safe PLA plastic, making it the ideal baking stamp. Its biodegradable components are derived from renewable sources, including corn starch, sugar cane, tapioca roots, or even potato starch.

Stamps are usually coloured pink, light pink, or hot pink. Colours may vary due to the supply of PLA.

Cleaning & Care Instructions
- Gently hand wash with warm water and a soft brush.
- Allow air to dry or dry with a soft cloth.
- Store stamps in an airtight bag or container, out of direct light.
- Please note that stamps are made from light plastic. Not suitable for dishwashers. - Avoid exposure to heat to prevent warping.

Use Instructions
- Make sure your fondant embosser is clean and dry.
- Roll out fondant to approximately 3mm thick (thicker if you prefer).
- Dust fondant lightly with corn flour or icing sugar, press stamp into the fondant.
- Lift the embosser to reveal the design.

Stamps can be used with fondant, sugar paste, gum paste, modelling paste, play dough, clay, and more.

Tips
You may or may not need to lightly dust with corn flour or icing sugar depending on the brand of fondant you use.

Design & Manufacture Information
Designs by Sweet Themes or Commercial Licenses have been purchased by the original designer.
Designed, printed and packaged in Australia.